The A5 By FiiO
Tonality7.8
Build & Functionality8
Matchability7
Value For Money8.5
7.8Our Score

FiiO started with amplifiers, that is how they made their name and the $129.99 A5 could be considered the 3rd generation of the original E12 which came out in 2013 and was then an answer to the crazy power output quest we all had when planars made a big comeback.

The E12 DIY was a refinement of the E12 born out of positive feedback on the MUSES02 opamp which was one of the rollable opamps FiiO offered with the E12 DIY Limited Edition in 2014.

In came the E12a in late 2014 with that MUSES02 opamp at the heart of its amplification stage and a smoother, somewhat darker tonal quality and a much more efficient output (<50% of the E12) that the rising IEM market audience could appreciate.

What Is The Pitch?

Best Of Both

So why do we need another variant? Well, the A5 is pitched as the best of both of the previous generation of E series analog amps. You have almost the same level of power from the older E12, something that was lost on the E12a as well as the improved channel balance and the lower noise floor (low gain) that we came to expect from the much less powerful E12a.

FiiO is banking on attracting both existing E12a users who want a bit more juice to drive their headphones as well as retaining IEM users with that continuing efficiency refinement. Note that both the E12 and E12a are no longer continuing to be made so in reality, new buyers will have only one choice, the A5.

Lower Price

In terms of product placement, the A5 is now also their flagship portable analog amp, sitting ahead of their A3 (previously the E11k) and the dinky little A1. Yet at the same time, FiiO have lowered the price of the A5 to $129.99 from the higher price level of the E12a which originally came out at $159.99 so kudos to FiiO for making their portable amp range just that bit more accessible.

Build

Color

The A5 comes in two colors, titanium and black, which, at the time of writing seems to be the two colors most in use by FiiO for the majority of their products. Mind you I can’t think of any compelling reason to petition them for blues, pinks and the red of the X5iii so two it is. The form factor of the A5 is also the exact same as the previous E12 and E12a though more in keeping with the E12a and the various little tweaks they introduced with that series.

Finish

There are some subtle differences though to the A5 you would only notice with the E12a sitting side by side. The first is the chassis sandblasted finish which to my mind is a bit more refined than the previous brushed metal design of the E12a, especially on the plate edges and cornering which is a bit smoother. The front plate in particular, around the pot, has a slightly more contoured finish than the previous E12a.

Volume Pot Change

The second is the pot itself. Now this one is a more debatable change as I liked the old pot on the E12a for its grippy surface. The new A5 pot is a bit more slimline and not as far out of the chassis and a little smoother and less grippy than before. On the other hand, it is more distinctive and refined looking than the older knob. FiiO has crafted the knob to mimic string instruments with its 56 45 degree lines laser etched into the center of the dial with a red ring finish. In summary, nicer looks but slightly harder to use than before.

CNC Stainless Steel Jacks

The third tweak is the headphone jack and line-in connectors. Gone are the old copper connectors and in comes new CNC milled stainless steel headphone connectors with plastic rings between the connector and the main chassis to plug the gap 100%. In theory, these stainless steel connectors should be more durable than the older copper ones and also in combination with the titanium color scheme on the review unit they do look a bit nicer.

Functionality

Inputs & Outputs

LED

In terms of I/O’s the A5 has the same positioning and type as the E12a. FiiO has retained the charging and blue power LED light configuration on the top left of the A5 as well as the gain control positioning on the front plate right beside the new volume pot.

Switches

The gain switch on the front plate itself stays the same as the E12a being slightly more accessible than the old E12 recessed switch with a decent resistance to prevent accident switching during volume control. The bass switch on the left panel remains unchanged, being discreet enough to prevent accidental knocks and just enough protrusion to make it easier to work with than the older E12 recessed switch.

Charging

The left panel is completed with a micro USB charging female port just a few millimeters down from the bass boost switch and will allow the A5 to charge from any 5v USB or plug socket with USB fitting. During charging the LED light on the top panel will flick red to denote charging (speed of blink will vary depending on how fast the charge is) and will cease to blink once fully charged.

Front Panel

As per the previous E12a and E12, the A5 back and right side panels are flush with no inputs or outputs. The front panel also remains unchanged also for the A5 with the line input to the far left and the headphone 3.5mm jack input central. Spacing is good, you should be able to easily slot in medium thickness 3.5mm plugs like Palic and still have room to spare to operate the gain switch and volume pot.

Amplification

Believe or not there has been no change to the fundamental chip use inside the A5 from the E12a. It is still the MUSES02 opamp and LME49600 buffer combo but what FiiO have instead focused on is everything else around those chips in terms of signal path, resistors, and an improved power management system.

THD

The goal here is to keep the efficient low noise floor that E12A users received but bring back the missing power of the original E12, or as close as can be (-80mW). FiiO has stated the new topology will give lower the THD by 33% over the older E12a from 0.03% to <0.002% (1 kHz) in the A5. This is still some way short of the ultra low THD results of the iBasso PB3 at less than 0.0005% but as far as portable budget amps these are pretty good numbers.

SNR

FiiO also claimed to have improved the SNR on the A5 to 115dB but I am not sure on this claim as the E12a spec sheet does say equal to or greater than 115dB also so perhaps real world measurements of the SNR of the E12a felt some way short of the paper specs. Again, a little short of the PB3 rating of 120dB but in comparison to the rest of the competition, it’s as good if not better. You should get some excellent dynamics from the A5 with a well-controlled noise floor yet decent power when required with either IEM or headphone.

Battery

The A5 packs the same 880mAh li-poly battery from the E12a but this time only offering up to 13 hours power with a relatively short 2-3 hour charge cycle from full drained. Real world tests are not too far off though you might get a slight diminution of the 13 hour charge time if you use the bass boost a lot or use headphones with a heavy draw.

E12a users will note that the old 20-hour life cycle is now reduced to 13 hours which is a bit of a hit. Much of this shortening is really due to the increased max output power of the A5 from 420mAh on the E12a to 800mAh on the A5. This is still reasonably competitive, marginally superior to the 12-hour playback of the Stoner Acoustics Ruby but sadly behind the iBasso PB3 which is outputting on a very strong 20 hours.

Accessories & Packaging

The A5 comes in FiiO’s new whiter retail themes packaging and includes a charging USB cable, the very cute 3.5mm short IC for line-in duties and keeping the low cable profile for stacking, 2 rubber stacking mats for knock protection, and 3 silicone bands for holding your A5 and source tightly together whilst stacks.

We first saw this shortened 3.5mm IC with the Q1 in 2015 and I am personally glad that FiiO has stuck with it because it does reduce cable clutter substantially. On the flip side if your source output is quite far or on the other side of the A5 line-in it might not be long enough.

It also comes with a similar polyester velcro locked soft carry pouch to the E12a and the quick start guide and warranty card. You get enough of a gap at the front of the pouch also to be able to connect both line-in cable and headphone jack without having to take out the A5 from the pouch though you will have to loosen the strap so I would not advise trying this whilst on the move.

Sound Impressions

Tonal Balance

Tonally the A5 is a largely neutral presentation with some warmth in its low-end response which is solid and meaty with competent extension and detail. The 5 staging is more depth than height with decent width though it is not quite as open sounding in the midrange performance as say the iBasso PB3, preferring instead to offer a resolving but more neutral midrange positioning. E12a users will find a degree of familiarity with the A5 tonality being equally smooth but with some tiny differences outside of the obvious power enhancement.

Bass

The first is the A5 additional body, particularly in the low end. This is both a positive and a slight negative if using the wide band bass boost of the A5 since the bass weight of the A5 without is already spot on. Those detecting warmth in the A5 response will largely find the more planted low end to be the welcome culprit here and certainly, it hits harder than other competing amps without any perceptible loss in detail or bleeding into the mids. The low-end coloration adds a welcome element of musicality to the A5 tonal presentation making it an excellent amp for rock and EDM.

Mids

The second tweak for me is a slightly lower emphasis on vocal performance on the A5 over the E12a. The more elevated and planted low end of the A5 and slightly more forward treble will take a little away from the neutral vocal performance whereas the E12a has less low-end and treble emphasis allowing the vocals to come to the fore a bit more.

Treble

The final change is a more subtle tweak and that is the introduction of a slightly more forward treble response to the A5 offering a touch more air and headroom than the E12a but it’s not huge. Compared to amps such as the pricier PB3 it retains very good control. It is perhaps slightly less rounded sounding than the super smooth PB3 but nothing I would class as edgy or sharp. It is actually quite a pleasing treble performance. You will not find anything peaky, sibilant, splashy or brittle about the A5 top end.

Transparency

There is also a decent level of transparency on the A5. Differing sources will temper the core signature of the A5 one way or another with the likes of FiiO’s own X5iii favoring a low to midrange physicality and iBasso’s DX200 more linear but better-extended DAC pushing more detail out.

Bass Boost

This is the only area of the A5 I was not overly enamored with as it’s more of a wide band low-end boost than anything specifically targeted. Bass boost introduces a >5dB gain in the A5 bass response right up to 100Hz. I think this overcooked slightly for my taste making the sound bloated and overly warm.

As you can see from the graph above the elevated doesn’t return to neutral to well into the mid-range smothering the lower mids and vocal range with that warm infuse. Clarity takes a big hit for me, particularly in the 200Hz to 1k range. I would love to have seen this around 2-3dB and focusing on sub-bass performance over mid-to-upper bass boosting.

Page 2: Matching & Comparisons

1 2

About The Author

Editor

Founder & Owner of headfonics.com. I first started reviewing in the late 80s (ouch!). Back then it was albums, rock concerts and interviews with a typewriter for the local rag. Now its desktop/portable and digital 2.1 audio on a rather nice laptop. How time flies.

Related Posts